Difference between revisions of "Winds Tab"

From VRTool wiki
Jump to: navigation, search
(Wind Grids)
Line 24: Line 24:
* Do all your downloads from a single source.
* Do all your downloads from a single source.
* Avoid overlapping grids.
* Avoid overlapping grids.
<br style="clear: both" />
<br style="clear: both" />

Revision as of 07:07, 6 October 2014

TabWinds.gif The following control panels are on the Winds tab:


The controls on this panel manage the appearance of the winds on the chart. There is nothing here that affects routing or track calculations, so you can safely experiment as you like to find out what each control does. The example settings shown here will give you a simple display of wind speed and direction with minimum clutter.

If you set the Wind arrow in scale control to [1] the length of each wind arrow will be the distance you will travel in one hour.

The two Wind filters options allow you to show or hide wind data according to how strong the wind is. If you set the show tws >= to say [5] then all the winds less then 5 knots will be blanked out on the chart. This is useful for highlighting holes in the wind that you need to avoid.

The wind values shown on the chart are those taken from the Grib files at the 1° Lat and Long ordinates. Remember that if you have Wind Interpolation turned on the wind speed and direction will vary between these 1° points. You can see this as you move the Ruler ToolbarRuler.gif, Route ToolbarRoute.gif, and Track ToolbarTracks.gif tools over the chart.

Wind Grids

This control panel is where the weather used by VRTool is managed. There is a lot going on in this panel!

When you download weather from any of the sources, the downloaded weather is contained in a weather "grid" and is added to list of grids in the window. The grids are automatically named - the name usually (but not always) identifies the area covered, a time-stamp and where it came from.

If you tick the overwrite previous wind grid box, a subsequent download for the same area and from the same source and will overwrite an existing grid. This means that when you repeat a download for a later forecast period an existing grid will be overwritten. On the other hand, if you alter the area boundaries of a download there will be no matching grid to overwrite.

This can get quite confusing and you can easily end up with active grids that overlap. If you find that the wind on the chart is different to the game the most likely cause is that you have multiple grids active for the location. As a general rule you should:

  • Keep the overwrite previous wind grid box ticked.
  • Do all your downloads from a single source.
  • Avoid overlapping grids.

Polars Database


Regatta Settings


Wind Interpolation